Control Arms

Vehicle Pulls to One Side Control Arm OE 48069-0E030 Diagnosis Guide

Control Arm 48069-0E030 Vehicle Pull Diagnosis

A persistent pull to one side on a flat road can be caused by a worn control arm bushing that shifts the wheel alignment. The control arm 48069-0E030 on Toyota Highlander is a common source of camber drift that makes the vehicle wander.

When the control arm bushing softens or cracks, the camber angle on that side changes, causing the vehicle to drift toward the side with the more negative camber.

What Is Control Arm 48069-0E030

The control arm 48069-0E030 is a lower rear control arm for Toyota Highlander and Lexus RX series SUVs. It maintains rear wheel alignment and suspension geometry.

How to Confirm the Pull Is From the Control Arm

  • Get a four-wheel alignment printout; check if camber or caster is out of spec on one side
  • Jack up the vehicle and inspect control arm bushings for cracking or deformation
  • Push on the tire while watching the control arm for excessive movement
  • Compare left and right sides; the side with more bushing movement is likely the failing side

Replacement Procedure

  • Remove the wheel and disconnect the sway bar link
  • Remove the control arm mounting bolts from the frame and knuckle
  • Install the new control arm and hand-tighten all bolts
  • Lower the vehicle to ride height before final torquing
  • Four-wheel alignment is mandatory

Our 48069-0E030 Control Arm

Our control arm 48069-0E030 matches OE dimensions for Toyota Highlander. Premium rubber bushings and direct bolt-on fitment.

Get Wholesale Quote

Send your VIN or OE number to confirm exact fitment. We supply wholesale suspension parts to repair shops and distributors.